Matte Black Dna 4 Megaphone Slip-on Exhaust Harley 95-16 Flhx Touring Mufflers
HARLEY SLIP ON MUFFLERS FOR ALL TOURING BAGGER MODELS. SATIN BLACK HEAT RESISTANT POWDER COAT.
INLET IS 1-7/8" DIAMETER TO FIT 1-3/4" DIAMETER OUTLET. (Electra Glide, Street Glide, Road Glide, Ultra Glide, Road King, FLHT/X/R, FLTR) with stock or 1 3/4 head pipes.Get the performance, sound, and the quality for a fraction of the cost of the competition. The removable, non riveted high performance baffle is designed to give you an amazingly deep sound. Tips are interchangeable - 3 styles of exhaust tips will be available in Fall 2015. Black megaphone slip on exhausts are now DOUBLE WALLED to completely prevent color warp. Satin Black High Temp 3-Stage coating process.
Total Length 29", 1 7/8" inlet, 4 outlet. Full length baffle starting at 1 3/4" and ending at 3". Part# M-TP-1010 / DNA -Megaphone Slip-On Exhaust. Note: Will not work on 2010 models with factory 2-into-1 systems. NOTE: TIPS & BAFFLES ON PIPES ARE REMOVABLE.
SLIP ON INCLUDES 2 MUFFLERS. PLEASE MESSAGE FOR FURTHER ASSISTANCE. NOT FOR SALE TO CALIFORNIA RESIDENTS......Choppershop1 makes every effort to accurately label Competition Use Only / Race Ready products intended for use on closed course competition motorcycles only; differentiating them from Highway / Street-Approved, everyday use products. Use of select racing products, which may not be emissions-compliant, on highway motorcycles is subject to California Air Resources Board (CARB) regulations and could be considered tampering with your vehicles ability to meet emissions standards. Californias anti-tampering law, Vehicle Code Section 27156 (VC 27156), prohibits the installation of any add-on or modified emission-related part of any pollution-controlled motorcycle, unless the part has been exempted by ARB.
Ultimately, it is the purchasers responsibility to determine suitability of parts for their motorcycle application and ensure compliance with ARB emissions regulations. California Air Resources Board (CARB) regulates motorcycle aftermarket parts that have the potential to impact emissions (Aftermarket Critical Emission Control Parts). In most cases, the sale and use of emissions related aftermarket parts on motorcycles is prohibited unless it is either a Replacement Part as defined by California, or is a specifically authorized use of that part as reflected in an Executive Order and labeled as an EO Part. These CARB regulations essentially place all emissions related aftermarket parts into three categories.
Replacement Parts are aftermarket parts that ARB considers to be functionally equivalent to the stock part they are intended to replace, and therefore would not impact the emissions (exhaust, evaporative, or both) from these vehicles. These parts are appropriate for sale and use on motorcycles used on or off the public highways. The label indicates the manufacturers name, wwwice name, and valid E. The format of the E. Number is D-XXX-XXX, where XXX is a series of designated numbers. The label is either affixed directly to the part itself or included with the part with instructions to install if in a visible location. Remember to always look for this label when shopping for emission-related aftermarket motorcycle parts.A listing of exempted motorcycle critical emission control parts in compliance with applicable California evaluation procedures can be found here. (3) Competition Use Only Parts. You may also visit ARBs website by clicking here for additional information. The item "MATTE BLACK DNA 4 MEGAPHONE SLIP-ON EXHAUST HARLEY 95-16 FLHX TOURING MUFFLERS" is in sale since Sunday, March 1, 2020. This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Exhausts & Exhaust Systems\Silencers, Mufflers & Baffles".
The seller is "choppershop1" and is located in Huntington Beach, California. This item can be shipped worldwide.